Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 408

¢ Dimensions
2-15/16(75)
Front View
¢ Installation
• Connection pattern
NOTE: Connection pattern is different according to type of Indoor unit.
Floor/Ceiling type
All wall mounted type
• Pattern A
1. Connect the end of remote controller cable directly to the exclusive terminal block.
2. Set the DIP switch (SW1) to "2WIRE" on the PCB of the indoor unit.
NOTES:
• Layout of terminal block and PCB is varies depending on the type of indoor unit.
• Operation may fail if it is connected to the outdoor unit or the terminal block for power
supply.
2-8. Simple remote controller (With operation mode: UTY-RSRY)
Hole: 3/8 × 3/16
3/4
(19)
Side View
Indoor unit type
All cassette type
All duct type
All floor type
All ceiling type
Functional earthing
(If necessary)
Remote controller cable
(Non-polar)
1-3/16
(30.0)
(9 × 4.5)
Hole: 1/4 × 3/16
(6 × 4.5)
Connection pattern
Terminal block
Indoor unit PCB
Set the DIP switch
(SW1) to "2WIRE"
- (05-70) -
Unit: in (mm)
1-3/16
(30.0)
7/8
(23.0)
Hole: 1/2 × 3/16
(12.5 × 4.5)
Rear View
Pattern A
Pattern B
2. Control units