Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 629

 Refrigerant circuit address setting
1. In the initial display of address setting mode, by pressing the SET BACK button, select a re-
mote controller address. (Select the indoor unit you want to operate.)
If the indoor unit you want to operate has already been selected, skip this step.
2. Display the function number "02" by pressing the SET TIME "<" button or SET TIME ">" button.
3. Set up the refrigerant circuit address by pressing the SET TEMP. "
button. (The setting range is from "00" to "99".)
4. Confirm the selected refrigerant circuit address data by pressing the TIMER SET button. The
data will be transferred to the indoor unit.
• When the address data is properly set up on the indoor unit, the flashing of the number stops
and the set number will be displayed. (GOOD)
• When the address data is not set up correctly, "- -" is displayed. (ERROR) Back to the previ-
ous step and set up the indoor unit address data again.
1-4. Address setting by remote controller
<: Down button
>: Up button
Remote controller address
Example: When remote controller address "01" is selected
Function number
Refrigerant circuit address data
Example: When refrigerant circuit address data "18" is set up
ERROR
- (07-29) -
" or the SET TEMP. "
GOOD
1. System settings
"