Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 636

6. Confirm the selected refrigerant circuit address data by pressing the START/STOP
The data will be transferred to the indoor unit.
• When the address data is properly set up on the indoor unit, the set number will be dis-
played. (GOOD)
• When the address data is not set up correctly, "- -" is displayed. (ERROR) Back to the previ-
ous step and set up the indoor unit address data again.
7. To return to the 2-wire remote controller address selection screen, press the START/STOP
button. If setting has been completed, press FAN "
selection screen.
When returning to the 2-wire remote
controller address selection screen
 Completion of setting mode
1. To exit the setting mode and return to the Menu 1 item selection screen, press and hold the
FAN " " button for 2 seconds or longer.
2. To return to the Monitor Mode screen, press and hold the TEMP. "
ton at the same time for 2 seconds or longer.
1-4. Address setting by remote controller
Example: When refrigerant circuit address data "18" is set up
ERROR GOOD
" button to return to the Menu 2-F1 item
Setting completed and returning to
the Menu 2-F1 item selection screen
- (07-36) -
button.
/
Indoor unit address
" button and FAN " " but-
1. System settings
/