Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 442

¢ Installation
• When the cable is attached to the wall:
– Remove the material covering the wiring penetration (thin material) in the cover of the sensor
unit with a pair of cutters. The cable passes through this hole.
– Attach the remote sensor unit on the wall using the screws.
– Fit the cover on the remote sensor unit and screw it in place.
• When the cable is buried in the wall:
– Remove the material (thinner than the surrounding material) in the wiring hole on the remote
sensor unit using a pair of cutters.
– Drill a hole in the wall for the cable.
– Seal the area around the cable penetration with putty.
– Fit the cover on the remote sensor unit and screw it in place.
¢ Specifications
Dimensions (H × W × D)
2-18. Remote sensor unit (UTY-XSZX)
Screw
(M4 × 5/8 [16])
Screw
[M4 × 5/8 (16)]
in (mm)
- (05-104) -
1-9/16 (40)
Mounting hole dimensions
13/16 13/16
(20) (20)
Ø1/4 (6) to Ø3/8 (10)
Mounting hole dimensions
2-3/4 × 2-3/16 × 11/16 (70.2 × 55.2 × 18)
Unit: in (mm)
2. Control units