Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 679

3. Press the FAN button to proceed to number setting. To return to the function number adjust-
ment, press the FAN button again.
4. Press the SET TEMP.
Each time the MODE button is pressed, it switches between the left digit and the right digit.
5. Send the information by pressing the START/STOP button once. A beeping sound (2 short
beeps, 1 long beep, 2 short beeps, and 1 long beep) will be emitted if the command is accept-
ed.
In the following case, the setting signal will not be accepted correctly and 5 short beeps will be
emitted:
• The function setting number is set out of range
2-4. Indoor unit (setting by wireless remote controller)
or button to adjust the setting number.
Beeps are emitted
intermittently
- (07-79) -
Change digit
(2 short beeps,
1 long beep, 2 short beeps,
and 1 long beep)
2. Function settings