Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 662

6. After all necessary function settings are completed, press the ENTER button (SW109) in the
setting completed state shown in the previous step.
5 seconds after, even if the ENTER button (SW109) is not pressed, the LED105 starts to flash
automatically.
LED105
Then, press the MODE/EXIT button (SW107) to exit the function setting mode.
LED105
2-1. Setting on outdoor unit PCB
LED105 LED104
LED104
LED104 LED105 LED104
- (07-62) -
2. Function settings