Table of Contents
Advertisement
RIGOL
Remote Control via USB
1. Connect the device
Use the USB cable to connect the rear-panel USB DEVICE interface of the signal
generator to the USB HOST interface of the PC.
2. Search for the device resource
Start up the Ultra Sigma and the software will automatically search for the
generator resources currently connected to the PC. You can also click
3. View the device resource
The resources found will appear under the "RIGOL Online Resource" directory,
and the model number and USB interface information of the instrument will also
be displayed.
For example, DG2102 (USB0::0x1AB1::0x0642::DG200000000001::INSTR).
4. Communication test
Right-click the resource name "DG2102
(USB0::0x1AB1::0x0642::DG200000000001::INSTR)" and select "SCPI Panel
Control" to turn on the remote command control panel, through which you can
send commands and read data. For details about the SCPI commands and
programming, refer to
Remote Control via LAN
1. Connect the device
Use the network cable to connect the signal generator to your local area
network (LAN).
2. Configure network parameters
Configure the network parameters of the signal generator according to "To Set
the LAN Parameters".
3. Search for the device resource
Start up Ultra Sigma and click
is displayed. Click
resources currently connected to the LAN and the resources found are displayed
at the right section of the window as shown in figure (b). Click
add it.
3-2
to search the resources.
DG2000 Programming Guide
and the software searches for the instrument
Chapter 3 Remote Control
.
. The window as shown in figure (a)
to
DG2000 User Guide
Advertisement
Table of Contents
