To Set The System Language; To Connect The Probe - Rigol DHO800 Series Quick Manual

To Prepare for Use
5.4
5.5
1.888.610.7664
• Shutdown:
- Click or tap
shutdown?" is displayed. Click or tap OK to shut down the instrument.
- Press and a prompt message "Are you sure to shutdown?" is displayed.
Click or tap OK to shut down the instrument.
- Press twice to shut down the instrument.
- Press for three seconds to shut down the instrument.
TIP
You can also click or tap
instrument powers on once connected to power.

To Set the System Language

This oscilloscope supports multiple languages. You can click or tap
Setup > Language to select the system language.

To Connect the Probe

RIGOL provides passive probes for DHO800 series. For specific probe models, refer to
DHO800 Data Sheet. For detailed technical information of the probes, please refer to
the corresponding Probe User Guide.
Connect the Passive Probe
1. Connect the BNC terminal of the probe to an analog channel input terminal of the
oscilloscope on the front panel as shown in the figure below.
2. Connect the ground alligator clip or spring of the probe to the circuit ground
terminal, and then connect the probe tip to the circuit point to be tested.
www.calcert.com
15
10 20
5 25
0 30
> Shutdown. Then a prompt message "Are you sure to
> Utility > Setup and set the "Power status" to "Switch on". The
> Utility >
sales@calcert.com