One-Key Measurement Of 24 Parameters - Rigol MSO4000 User Manual

RIGOL
6 To Make Measurements

One-key Measurement of 24 Parameters

Press MENU at the left of the screen to turn on the measurement menu of the 24
waveform parameters and then press the corresponding menu softkey to quickly
realize "One-key" measurement. The measurement result will be displayed at the
bottom of the screen.
Note: When the measurement source is set to D0-D15, the "one-key" measurement
only supports period, frequency, positive width, negative width, positive duty cycle,
negative duty cycle, delay and phase.
The icons of the time and voltage parameters in the measurement items and the
measurement results on the screen are always marked in the same color with the
channel (Measure  Source) currently used. But the delay and phase
measurement items are always marked in green. For example,
Parameter Icons:
Measurement Results:
Note: If the measurement result is displayed as "*****", it means that there is no
signal input in the current source or the measurement result is not within the valid
range (too large or too small).
MSO4000/DS4000 User's Guide
6-14