System Setting; Software Dipsw Setting - Konica Minolta bizhub PRO 1050 Service Manual

Field Service Ver3.0 Nov.2006

10.9 System setting

10. 10.9.1

Software DIPSW setting

Config Configure settings for the software DIPSW.
NOTE E
• DIPSW bits data are written into the parame- W bits
ter board (PB) every time a change is made. d (PB)
Do not change data hastily, for they cannot ange d
be automatically restored. lly res
• Do not change any switch not described in any sw
the service manual.
A. Procedure
1. Enter the service mode.
2. "Service mode menu screen"
Press the [07 System Setting] key.
3.
A sub menu appears on the right side of the
screen.
Press the [01 Software SW Setting] key on the
sub menu.
4.
"Software switch setting mode screen"
Press the [ ], [ ] key or the numeric keys to
select a DIPSW bit number.
5. Press the [On (1)] or [Off (0)] key to set the
selected bit number ON/OFF.
6.
Press the [Return] key to return to the "Service
mode menu screen" on which the sub menu
was displayed.
Info HJG:
Siehe DIPSW Liste von HJG
B. Software DIPSW setting screen
[1] [2] [3]
[1] DIPSW number
[2] 8-bit switch values indicated in hexadeci-
mals from 00 to FF.
of the
[3] Bit number (0 to 7)
[ [4] Bit data: On (1), Off (0)
10. SERVICE MODE
[4]
429