Konica Minolta bizhub PRO 1050 Service Manual page 597

14. MALFUNCTION CODE
Classification Code
Tray /4 SC18-41 When the upper limit sensor /2
SC18-42 When the upper limit sensor /2
SC18-43 When the upper limit sensor /2
Tray /5 SC18-50 The locking of the paper lift motor
SC18-51 When the upper limit sensor /3
SC18-52 When the upper limit sensor /3
562
Causes
(PS77) is OFF, PS77 does not turn
ON within 20 seconds after the
paper lift motor /2 (M43) turns ON
for lifting operation. And at this
time, an error detection signal
(24V cut off) is detected.
(PS77) is OFF, PS77 does not turn
ON within 20 seconds after the
paper lift motor /2 (M43) turns ON
for lifting operation. And at this
time, an error detection signal
(blowout of a fuse) is detected.
(PS77) is OFF, PS77 does not turn
ON within 20 seconds after the
paper lift motor /2 (M43) turns ON
for lifting operation. And at this
time, an error detection signal is
not detected.
/3 (M44) is detected.
When M44 is ON, an error detec-
tion signal of the M44 is detected.
(PS83) is OFF, PS83 does not turn
ON within 20 seconds after the
paper lift motor /3 (M44) turns ON
for lifting operation. And at this
time, an error detection signal
(24V cut off) is detected.
(PS83) is OFF, PS83 does not turn
ON within 20 seconds after the
paper lift motor /3 (M44) turns ON
for lifting operation. And at this
time, an error detection signal
(blowout of a fuse) is detected.
Field Service Ver3.0 Nov.2006
Resulting Estimated abnormal parts
operation
Error code is not DC power supply /2 (DCPS/
displayed on the 2)
operation panel,
but displayed only
on the data collec-
tion, the list output
and CSRC. Since
the lifting opera-
PF drive board (PFUDB)
tion of the tray is
not completed,
"Set paper in the
tray 4" is displayed
on the operation
board.
Error code is not Paper lift motor /2 (M43)
displayed on the
operation panel,
but displayed only
on the data collec-
tion, the list output
and CSRC. Since
the lifting opera-
tion of the tray is
not completed,
"Set paper in the
tray 4" is displayed
on the operation
board.
The main body Paper lift motor /3 (M44)
stops immediately Upper limit sensor /3 (PS83)
to turn OFF the
RL1 (main).
Error code is not DC power supply /2 (DCPS/
displayed on the 2)
operation panel,
but displayed only
on the data collec-
tion, the list output
and CSRC. Since
the lifting opera-
PF drive board (PFUDB)
tion of the tray is
not completed,
"Set paper in the
tray 5" is displayed
on the operation
board.