List Output - Konica Minolta bizhub PRO 1050 Service Manual

10. SERVICE MODE

10.7 List output

Conduct various list outputs, test pattern outputs and
running tests.
10.7.1 List output
Output various lists.
(1) Procedure
1. Enter the service mode.
2. "Service mode menu screen"
Press the [05 List Output] key.
3.
A sub menu appears on the right side of the
screen.
Press the [01 List Output] key.
4. "List output mode menu screen"
The list output mode menu includes the follow-
ing items.
• Machine Management List
• Adjustment Data List
• Pixel Ratio Data List
• Parameter List
• Font Pattern
• Communication Log List *1
• Memory Dump List
Note
• If you set DIPSW30-1 to 1, the parameter
list and after are displayed.
• Do not use the parameter list and the mem-
ory dump list in the field because they are
for development.
5. Press the key for an item you want to output.
6.
"List output mode menu screen"
Press the [COPY] key.
7. Press the Start button to output the selected
list.
8.
Press the [SERVICE] key.
9.
"List output mode menu screen"
To output other lists, repeat steps 4 to 8.
*1 Prints out the latest 30 items of the sending and
receiving history of the mail remote notification
system and the CS Remote Care. The start time
of communications, the time period of communi-
cations (modem only), the communication
modes, the results of communications, and the
senders (mail only) are printed. The communica-
420
Field Service Ver3.0 Nov.2006
tion modes and the results of communications
are displayed in the numbers of 4 digit number.
For the meaning of them, refer to the table
below.
Communication mode
0000 —
0001 Initial transmission
0002 Emergency trans-
mission
0004 Emergency recovery
transmission
0005 —
0008 Transmission for
warning
0010 Warning recovery
transmission
0020 Maintenance start
transmission
0040 Maintenance com-
pletion transmission
0080 Administrator trans-
mission
0100 Fixed date transmis-
sion
0200 Response transmis-
sion
0*** —
1000 Enquiry
2000 Data rewrite
4000 Response reception
8000 Test mail
The SMTP reply codes (200 to 554) prescribed in the
RFC1846, 2554 and 2821 are displayed in this place
of ***.
Results of
communication
Transmitted
successfully
Connection time out
when transmitting
—
Received
successfully
Reception failed
—
—
—
—
—
—
—
Transmission failed
—
—
—
—