Konica Minolta bizhub PRO 1050 Service Manual page 520

Field Service Ver3.0 Nov.2006
10. Enter a value through the numeric keys and
press the [Set] key.
• Setting range:-20 (narrow) to +20 (wide)
1 step = 0.1mm
11. Repeat steps 5 to 10 until the standard value
can be obtained.
G. Trimming adjustment
When there is misalignment in the trimmed fore-edge
or the trimming is too much, conduct this adjustment.
(1) Procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [11 Finisher Adjustment] key.
3. A sub menu appears on the right side of the
screen.
Press the [06 Saddle Stitcher Adj.] key on the
sub menu.
4. "Saddle Stitcher Adjustment Menu screen"
Press the [07 Trimming Adjustment] key.
5.
"Trimming Adjustment screen"
Press the [COPY] key.
6.
Set the paper of the paper size you want to
adjust. Press the Start button to output the test
pattern (No. 16).
7.
Check the trimming distance "a" on the cover
paper.
• Standard value: a = 2 mm or more
Note
• Trimming distance less than 2mm may
cause trimming fault.
a
8. When the value is not within the standard value,
press the [SERVICE] key.
9.
"Trimming Adjustment screen"
Use the [Next] and [Back] key to select the
paper size you want to adjust.
10. Enter a value through the numeric keys and
press the [Set] key.
• Setting range:-400 (smaller) to +400 (larger)
11. Repeat steps 5 to 10 until the standard value
can be obtained.
fs503fs3301c
10. SERVICE MODE
1 step = 0.1mm
1
485