Konica Minolta bizhub PRO 1050 Service Manual page 340

6. OTHERS
[6]
[5]
[7]
[4]
[2]
[4]
[5]
[1]
308
[1]
[3]
1050fs2022c
[6]
[7]
[3]
[2]
1050fs2023c
Field Service Ver3.0 Nov.2006
5. Turn over the transfer/separation charger unit [1]
and tighten the wiring harness of the existing
connector [2] and the wiring harness of the size
detection connector [3] with the wiring band [4].
NOTE
• Be sure to install the wiring harness of the
size detection connector [3] so that the rear
end section [5] does not protrude from the
inner end [7] of the connector bracket plate
[6]. If it is protruding, the wiring harness may
be broken.
• For the size detection connector, it is neces-
sary to install the one corresponding to the
size to be used. This can be identified by the
wire color of the size detection connector.
(See P.306)
6. Remove the screw [1] and then remove the lever
A [2].
7.
Open the open/close guide /1 [3].
8. Loosen 2 screws [4] and remove the ADU cover /
Lt [5].
9. Loosen 2 screws [6] and remove the ADU cover /
Rt [7].