Konica Minolta bizhub PRO 1050 Service Manual page 148

3. PERIODIC CHECK
E. Replacing the transfer/separation charger unit
(1) Periodically replaced parts/cycle
• Transfer/separation charger unit: Every 6,000,000 prints
(2) Procedure
[3]
[1]
116
[1]
[2]
1050fs2019c
[4]
[3]
[2]
1050fs2020c
Field Service Ver3.0 Nov.2006
1.
Pull out the ADU from the main body.
2. Remove the screw [1] and then remove the con-
nector cover [2].
3. Disconnect the connector [1].
NOTE
• When the transfer/separation charger unit is a
PCS corresponding part (See
sponding parts"), remove also the connector
[2].
4. Loosen 2 screws [3] and remove the transfer/
separation unit [4].
5.
Reinstall the above parts following the removal
steps in reverse.
(See P.112)
"6.5 PCS corre-