Konica Minolta bizhub PRO 1050 Service Manual page 524

Field Service Ver3.0 Nov.2006
E. Pasting finish position adjustment
Adjusts the position to finish applying glue.
(1) Procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [11 Finisher Adjustment] key.
3.
A sub menu appears on the right side of the
screen.
Press the [07 Perfect Binder Adjustment] key
on the sub menu.
4.
"Perfect Binder adjustment mode menu screen"
Press the [05 Pasting Finish Position Adjust-
ment] key.
5.
"Paste Finish Pos. Adj. screen"
Press [Go Ahead] or [Go Back] to select which
finish position, for applying during frontward
movement or backward movement, to be
adjusted.
6.
Press [Next] or [Back] key to select the paper
size from the following options.
All Size
8.5 x 11
A4
B5
A5
5.5 x 8.5
16K
A4W
B5W
A5W
8.5 x 11W
5.5 x 8.5 W
Special
Note
• Above paper sizes are book (the inside
pages) finished sizes.
7. Press the [COPY] key.
8.
Select the paper type and press the start but-
ton to make test prints and carry out perfect
binding.
9. Check that the glue applying finish position to
the inside pages is appropriate.
[2]
[1] Finish position for frontward applying
[2] Finish position for backward applying
[3] Inside pages
10.
To adjust the finish position, press the [SERV-
ICE] key.
11. "Paste Finish Pos. Adj. screen"
Enter a value through the numeric keys and
press the [Set] key.
• Setting range:-128 (earlier) to +127 (later)
1 step = 0.1mm
12.
Repeat the steps 5 to 11 until an appropriate
value is obtained.
10. SERVICE MODE
[3]
[1]
1050fs3361c
489
2