Konica Minolta bizhub PRO 1050 Service Manual page 508

Field Service Ver3.0 Nov.2006
B. Hole-punch vertical position adjustment
Adjust punch holes in the sub scan direction.
(1) Procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [11 Finisher Adjustment] key.
3.
A sub menu appears on the right side of the
screen.
Press the [02 Multi Folder (Punch) Adj.] key on
the sub menu.
4.
"Multi Folder (Hole-Punch) adj. menu screen"
Press the [02 Hole-Punch Vertical Position
Adjustment] key.
5.
"Punch Vertical Position Adj. screen"
Press the [COPY] key.
6.
Set the paper of the paper size you want to
adjust in the tray, and select the number of
punch holes. Press the Start button to output
the test pattern (No.16).
7.
Check the distance a from the outputted paper
leading edge to the punch holes center posi-
tion.
a
Holes Standard value a (mm)
2 & 4 holes 10.5 ± 5.0
3 holes 9.5 ± 5.0
8.
When the value is not within the standard value,
press the [SERVICE] key.
9. "Punch Vertical Position Adj. screen"
Use the [Next] and [Back] key to select the
paper size you want to adjust.
10.
Press the punch hole key you want to adjust.
11. Enter a value through the numeric keys and
press the [Set] key.
• Setting range:-40 (wide) to +40 (narrow)
12. Repeat steps 5 to 11 until the standard value
can be obtained.
13.
To configure other punch hole/paper size,
repeat steps 5 to 11.
fs503fs3013c
10. SERVICE MODE
1 step = 0.1 mm
473