Konica Minolta bizhub PRO 1050 Service Manual page 136

3. PERIODIC CHECK
[4]
[1]
104
4. Remove 2 E-rings [1], and then remove 2 plastic
washers [2], 2 bearing [3] and the conveyance
roller /1 [4].
NOTE
• When removing and reinstalling the convey-
ance roller /1 [4], be careful that it does not
get damaged by the corners of the guide
plate.
• When reinstalling the bearing [3], be sure to
raise the conveyance guide plate so that it
gets into the jam release condition.
[3]
5.
Reinstall the above parts following the removal
steps in reverse.
[2]
NOTE
• After completion of the installation, check to
see if the roller rotates smoothly.
[3]
[2]
[1]
1050fs2742c
Field Service Ver3.0 Nov.2006