Konica Minolta bizhub PRO 1050 Service Manual page 642

Field Service Ver3.0 Nov.2006
Classification Code
Image SC46-61 The scan operation starts before
pro-
cess-
ing
abnor-
SC46-62 The print operation starts before
mality
SC46-63 The AGC is retried due to the
SC46-64 A PWM gamma curve is not cre-
SC46-66 Shift amount abnormality while in
SC46-80* The message queue is insufficient
SC46-81* The parameter value is in excess
SC46-82* The ID of the task that sends the
SC46-83* The receiving event of the mes-
SC46-90* Memory access abnormality.
SC46-91* Header readout address abnor-
SC46-99* DIMM memory abnormality. An
IC SC49-01 Printer controller initial communi-
Con-
troller
SC49-03 Transfer error to the main body
abnor-
mality
SC49-04 Hard disc /2 (HDD2) abnormality
SC49-05 IC cooling fan (FM24) lock abnor-
SC49-06 Unregulations IP error.
SC49-07 The CF version is different from
Causes
the original skew adjustment is
terminated. (The skew adjustment
is too late.)
the paper mis-centering adjust-
ment is terminated. (The mis-cen-
tering adjustment is too late.)
decreased light volume of the
exposure lamp. However, no error
occurs.
ated properly.
the repeat (when the width is
specified, or in the auto mode).
When the shift amount while in the
repeat is negative (-).
or destroyed.
of the permissible limits.
message queue is undefined.
sage is undefined.
mality.
error is detected in the DIMM
memory check at the start.
cation abnormality
image memory
mality
the version information in the hard
disc /2 (HDD2).
14. MALFUNCTION CODE
Resulting Estimated abnormal parts
operation
Error code is not ADF
displayed on the Original skew sensor /Fr
operation panel, (PS312), /Rr (PS311)
but displayed only
on the data collec-
Centering sensor (PS54)
tion, the list output
and the CSRC.
The control of the
main body is
Exposure lamp (L1)
made by using a
data previously
obtained.
Toner control sensor board
(TCSB)
If there is a copy Image processing program
being made, the
main body com-
Image processing board
pletes the paper
(IPB)
exit before stop-
ping operations.
Turn OFF the RL1
(main).
The main body IC board (ICB)
stops immediately Hard disk /2 (HDD2)
to turn OFF the
IC board (ICB)
RL1 (main).
IC board (ICB)
Hard disk /2 (HDD2)
IC board (ICB)
–
Hard disk /2 (HDD2)
format HDD2
607
2