Konica Minolta bizhub PRO 1050 Service Manual page 506

Field Service Ver3.0 Nov.2006
"Stapling Paper Width Adj. screen"
11.
Enter a value with the numeric keys and press the
[Set] key.
• Setting range: -20 (wide) to +20 (narrow)
1 step = 0.1 mm
Repeat steps 5 to 11 until the standard value can be
12.
obtained.
C. Paper Width (Staple Mode)
Adjust an uneven paper stack (main scanning direction)
on the main tray in non-sort and sort mode.
This adjustment adjusts the position of the alignment
plate while in alignment.
(1) Procedure
Enter the service mode.
1.
"Service mode menu screen"
2.
Press the [11 Finisher Adjustment] key.
A sub menu appears on the right side of the screen.
3.
Press the [01 Stapler Position Adj.] key on the sub
menu.
"Staple Finisher adjustment mode screen"
4.
Press the [02 Paper Width Adjustment] key.
"Stapling Paper Width Adj. screen"
5.
Press the [Staple Mode] key and press the [COPY]
key .
Select the paper size according to the item you
6.
want to adjusted and press the Start button to out-
put a test pattern (No. 16).
Open the front door of the FS and pull out the
7.
stacker.
Note
• If the length of the paper is longer than 239 mm
in sub-scanning direction, the paper edge will
hanging out of the stacker. In that case, remove
the paper through the paper opening section
before pulling out the stacker, and reload the
paper in the stacker.
Measure the gap between the paper in the stacker
8.
and the alignment plate.
Standard value: 0 ± 0.5 mm
When the value is not within the standard value,
9.
press the [SERVICE] key.
"Stapling Paper Width Adj. screen"
10.
Use the [Next] and [Back] key to select the paper
size you want to adjust.
11.
• Setting range: -20 (wide) to +20 (narrow)
12.
(Heftmodus)
Achtung:
Ab FW Ver. 4x ist es möglich folgende
Justagen separat durchzuführen.
a) Straight Mode
b) Staple Mode (Heftmodus)
"Stapling Paper Width Adj. screen"
Enter a value with the numeric keys and press the
[Set] key.
1 step = 0.1 mm
Repeat steps 5 to 11 until the standard value can be
obtained.
(reine Blattausgabe)
10. SERVICE MODE
471-1
471
470-1
2