Konica Minolta bizhub PRO 1050 Service Manual page 74

3. PERIODIC CHECK
C. Replacing the charger unit
NOTE
• When removing the charger unit, be careful not to touch the mesh portion of the charger control
plate with bear hands.
• When cleaning the charger control plate, blow off dirt with the blower brush.
(1) Periodically replaced parts/cycle
• Charger unit: Every 6,000,000 prints
(2) Procedure
[2]
[5]
[4]
42
1. Pull the photo conductor section out of the main
body.
[3]
2.
Disconnect the connector [1] and remove the
wiring harness of the charger from the harness
clamps [2] at the 3 places.
3.
Hold the portions marked with [3] and [4] and
remove the charger unit [5].
4.
Reinstall the above parts following the removal
steps in reverse.
[1]
1050fs2096c
Field Service Ver3.0 Nov.2006
(See P.38)