Installing A Monitor And Keyboard; Installation Procedure - adept technology MV User Manual

Chapter 3

Installing a Monitor and Keyboard


The peripheral equipment such as the keyboard and monitor
supplied by Adept are intended for use in light industrial
conditions. In more severe conditions, they should be protected
with a suitable enclosure.

Installation Procedure

An Adept controller can be configured with a color monitor and an extended
keyboard with built-in trackball. Both of these devices can connect to the optional
VGB board. See the
keyboard and trackball.
See Figure 3-6
1. Make sure the controller is turned off before making any connections.
2. Verify that the voltage range marked on the monitor is compatible with your
local voltage source. Connect the color monitor AC power cord to the monitor,
then plug it into an appropriate voltage source.
3. Connect the monitor signal cable to the
4. Connect the double-ended keyboard cable to the
%*/
,-
the
64
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com


      for details on using the
for details; the steps are listed below.
connector on the VGB board.
Adept MV Controller User's Guide, Rev. B

Installing a Monitor and Keyboard

.*/
*-
connector on the VGB board.
4, 5*-6
connector and