Connecting User-Supplied Serial Communications Equipment; Rs-232 (Jcom) Connector - adept technology MV User Manual

Chapter 5
Connecting User-Supplied Serial Communications
Equipment

RS-232 (JCOM) Connector

There is one RS-232 serial port (JCOM) for general-purpose serial I/O functions
on the CIP (see
and its pin locations). This serial port is referred to as device
serial port can be accessed by any Adept system processor configured to run V
The connector is a 9-pin DB-9 male receptacle. The signal and pin information are
shown in 94%
( .
+
See the V Language User's Guide
Instructions for Adept Utility Programs
*/7) 8
using the
at up to 38,400 bps.
Pin Signal
1 Not used
2 RXD
3 TXD
4 Not Used
5 SG (Signal
Ground)


The serial port on the CIP does not provide hardware
handshaking signals
110
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Connecting User-Supplied Serial Communications Equipment

'  
( '  
(
and
for information on serial I/O. See the
program. The serial port on the CIP can be configured for use
Table 5-4. JCOM Connector Pin Assignments
Pin
6
7
8
9
9
5
Figure 5-8. JCOM Pin Locations
Adept MV Controller User's Guide, Rev. B
for the location of the JCOM connector
0* 0',-0:;
for default configuration information
Signal
Not used
Not used
Not used
Not used
6
1
This
.
+
.