Adept Supplied Devicenet Hardware; Connecting Devicenet Hardware To The Adept Device Net Scanner - adept technology MV User Manual

Appendix G

Adept Supplied DeviceNet Hardware

Adept supplies the following DeviceNet hardware in the CIP:
Micro-style 12 mm thread DIN connector (female). See
assignments.
Installed on the Adept XL series of robots is a DeviceNet cable that you can
use to route signals from the base of the robot to the outer link. See
for a drawing of the connectors.
Connecting DeviceNet Hardware to the Adept DeviceNet Scanner
To connect DeviceNet components to the Adept DeviceNet Scanner, connect a
dropline to the female Micro-style 12 mm thread DIN connector on the back of the
CIP. Then you must configure the DeviceNet Scanner correctly using the
program. See the DEVICENET instruction in the
*/7)8
Reference Guide
+
V .


Adept does not supply 24V on the CIP to power the
DeviceNet bus. A separate power supply is required to power the
components on the DeviceNet bus.
  

and CAN_L signal lines tolerate voltages up to 18V. Since the
supply voltage exceeds 18V, improperly wiring the supply voltage
to these signal lines may cause permanent damage.
382
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table G-1. DeviceNet Signal to Pin Locations
Pin Signal Name
1 Drain
2 V+
3 V-
4 CAN_H
5 CAN_L
for detailed information about the DeviceNet software setup in
The DeviceNet specification requires that the CAN_H
Adept MV Controller User's Guide, Rev. B

Adept Supplied DeviceNet Hardware

94%
$(
+
V Language
for Pin
'  
$(