Vme Bus Address And Configuration; Evi Motherboard Dip Switch Setting - adept technology MV User Manual

Chapter 7

VME Bus Address and Configuration

The EVI board will be configured as board 1 unless the system is running the dual
AdeptVision option, in which case the second EVI board will be board 2. If you
have only one EVI board installed, it will be set correctly when the controller is
shipped to you.

EVI Motherboard DIP Switch Setting

If you install a new EVI board (as a replacement part or upgrade) or have the dual
vision option, see the tables below for the address switch settings. The shaded
cells indicate the settings that are different for each board. See
location of SW1 on the EVI board. See
settings.
When setting the switches, you should rotate the board 90
NOTE:
degrees clockwise from the orientation shown in
VME bus connectors will be pointing toward you).
SW2
SW7
SW6
SW5
SW4
SW3
SW1
EVI Daughter Board
EVI Daughter Board
DIP and Rotary
DIP & Rotary
Switches
Switches
142
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SW8
Adept EVI Board - Component Side
Adept EVI Board – Component Side
Figure 7-1. Switch Locations on EVI Board
Adept MV Controller User's Guide, Rev. B

VME Bus Address and Configuration

Figure 7-2 for the position of the A and B
Figure 7-1
EVI Mother Board
DIP Switches
Figure 7-1 for the
(the
EVI Mother Board
DIP Switches