Ascii Terminal; Auto Boot; Cpu Board Number Assignment; System Controller Jumper Settings - adept technology MV User Manual

Chapter 4

ASCII Terminal

When using an ASCII Terminal as the user interface, set DIP switch SW1 as
follows:
Table 4-6. ASCII Terminal Settings of DIP Switch SW1
SW 4 SW 3 SW 2
ON ON OFF

AUTO Boot

When using the AWC board in an AUTO Boot configuration, set DIP switch SW1
as follows:
Table 4-7. Auto Boot Settings of DIP Switch SW1
SW 4 SW 3 SW 2
OFF OFF OFF

CPU Board Number Assignment

An AWC 060 main processor and an AWC 060 auxiliary processor may be
installed in the same Adept MV controller chassis. Each AWC board must have a
unique board address. The address is set on DIP Switch SW1 on the AWC board.
94%
(
shows the switch settings for all processor module combinations
including CPU #1 and CPU #2. See

System Controller Jumper Settings

In Adept controllers, this jumper should not be installed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SW 1 Interpretation
ON CPU #1, no auto boot, user interface via serial port
SW 1 Interpretation
OFF CPU #1, normal operation (per NVRAM settings)
'  
(
Adept MV Controller User's Guide, Rev. B
Configuring an AWC Module
for the location of DIP switch SW1.
81