Acquisition Switch Setting Mode - adept technology MV User Manual

Chapter 7
Figure 7-2. Rocker (Dip) Switch Positions for SW1 on Motherboard
Refer to the settings shown in
your Adept MV controller.
1
SW1 B
If you add a second EVI board in your controller, refer to the settings shown in
Table 7-2 when installing the second board.
1
SW1 B
SW1-3 (3rd switch on SW1) selects either:
• B: POS_LATCH 1 and VIS_TRIGGER 1 (recommended for EVI board 1)
or...
• A: POS_LATCH 2 and VIS_TRIGGER 2 (recommended for EVI board 2)
All other switches on SW1 should be set as shown above.

Acquisition Switch Setting Mode

The acquisition mode switches are located on the EVI daughterboard. There is
one DIP switch bank (SW1) and seven three-position rotary switches (SW2 - SW8)
that must be set. See
on the EVI board.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
A
B
and Daughterboard
Table 7-1
Table 7-1. Switch Settings for EVI Board 1
2 3
B A A
Table 7-2. Switch Settings for EVI Board 2
2 3
B A A
Figure 7-1 for the location of the acquisition mode switches
Adept MV Controller User's Guide, Rev. B
VME Bus Address and Configuration
when installing the first EVI board into
4 5 6
A A
4 5 6
A A
7 8
A A
7 8
B A
143