Chapter 7
Installing Camera Cables
See the
AdeptVision User's Guide
strobes in your system.
RS-170 breakout cable and the associated hardware.
CAUTION:
camera or cable. Failure to do this may damage the EVI board.
Connecting the Cables to the RS-170 Standard Camera
This section describes the steps for connecting the cables between the EVI board
and the RS-170 Cameras.
1. Turn off the Adept MV controller.
2. Connect the camera to a 10m camera cable.
3. Connect the 10m camera cable to the appropriate connection on the camera
breakout cable.
4. Connect the power supply and strobe lamps through the 9 pin D-sub
connector (see
5. Connect the camera breakout cable to the camera/strobe connection on the
EVI board.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
for information on mounting cameras and
Figure 7-7
shows the installation of a typical four-camera
Turn off the controller before installing or removing a
Table 7-7
for pin assignments).
Adept MV Controller User's Guide, Rev. B
Installing Camera Cables
151