Optional Dio Cables; Labeling Cables; Input And Output Cable Wiring Information - adept technology MV User Manual

Chapter 5

Optional DIO Cables

The cables that connect to the input and output connectors on the DIO board can
be ordered as a set of four cables: two input cables and two output cables. These
cables have a mating plug on one end and unterminated flying leads on the other
end. The wire size of the Adept cables is 0.18 mm
cables to connect to the digital inputs/outputs in your system or to a wiring
block.
To comply with IEC 1131, if you choose to supply a wiring block, it should be
capable of accepting wire in the range of 0.18 mm
AWG).

Labeling Cables

The JDIO1 and JDIO2 input connectors on the front of the CIP are similar except
that JDIO1 handles the group 1 and group 2 input signals and JDIO2 handles the
group 3 and group 4 input signals. The optional digital input cables can be
connected to either JDIO1 or JDIO2. Make sure to clearly label the cables once you
have completed your installation so that the cables do not get swapped by
mistake; see the warning below.
The JDIO3 and JDIO4 output connectors are also similar except that JDIO3
handles the group 1 and group 2 output signals and JDIO4 handles the group 3
and group 4 output signals. The optional digital output cables can be connected to
either JDIO3 or JDIO4. Make sure to clearly label the cables once you have
completed your installation so that the cables do not get swapped by mistake; see
the warning below.



cables so that they are always plugged into the correct connector.
Swapping the JDIO1 and JDIO2 or JDIO3 and JDIO4 cables could
cause damage to your equipment. Depending on the installation,
this could potentially cause injury to personnel in the area.
These cables all also used for wiring the DIO boards. If you use both
the extended DIO on the CIP and optional DIO boards, make sure
all cables are clearly marked.

Input and Output Cable Wiring Information

The pinouts, signal names, and wire color information for the input and output
cables are shown in the next four tables.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Make sure to clearly label the JDIO1 to JDIO4 digital I/O
Adept MV Controller User's Guide, Rev. B

Optional DIO Cables

2
(24AWG). You can use these
2
(24 AWG) to 2.0 mm
2
(14
125