Labeling Sets Of Cables - adept technology MV User Manual

Chapter 12

Labeling Sets of Cables

The optional Adept input and output cables for the DIO boards are the same for
each additional board that you add to a controller. Make sure to clearly label each
set of four cables so that they are identified with a specific DIO board. Also see the
warning on page 200
cables with each other.
Adept DIO Board - Component Side
Figure 12-3. Switch and Jumper Locations on the DIO Board
206
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
about swapping the two input cables or the two output
J3
J4
J5
J6
Adept DIO Board – Component Side
Adept MV Controller, User's Guide, Rev. B
Additional DIO Boards
SW1
B
A
Typical J3 to J6
Typical J3 to J6