Table of Contents
Advertisement
Chapter 3
For installations in Europe to maintain compliance with
EN 60204-1, the mounting of the controller and all terminations at
the controller must be performed in accordance with this standard.
Space Around the Chassis
When the stand-alone controller is installed, you must allow 25 mm (1 inch) at the
left and right sides of the chassis for proper air cooling. You must also allow 75
mm (3 inches) at the front of the chassis for power and signal cable clearance.
system can work efficiently. See
the filter.
Rack Mounting
To rack mount the Adept MV-5 or MV-10 stand-alone controller in a standard
19-inch equipment rack, you must use the mounting brackets from the accessories
kit. See
Figure 3-7
Side View of MV-5 or MV-10
Side View of MV-5 or MV-10
Figure 3-7. Rack Mounting for MV-5/MV-10 Stand-Alone Controller
Panel Mounting
To panel mount the Adept MV-5 or MV-10 stand-alone controller, you must use
the mounting brackets and screws from the accessories kit. See
instructions.
68
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Installing a Stand-Alone Controller in a Rack or Panel
The air filter must be kept clean so the forced air cooling
for instructions. See
Front
Front
Adept MV Controller User's Guide, Rev. B
Chapter 13
for details on cleaning
Appendix A
for dimensions.
To install mounting brackets in rack mount
position:
To install mounting brackets in rack mount
position:
•
Remove 4 existing screws and washers
from side of chassis at locations shown in
• Remove 4 existing screws and washers
drawing.
from side of chassis at locations shown
in drawing.
•
Place bracket in position and secure with
same screws and washers removed above.
• Place bracket in position and secure
•
Repeat process for other side of controller.
with same screws and washers removed
above.
• Repeat process for other side of controller.
Figure 3-8
for
- Quick Links:
- Developer's Manuals
Hide quick links:
Advertisement
Table of Contents
