Camera Cables; Four-Camera Breakout Cable For Rs-170 Cameras - adept technology MV User Manual

Chapter 7

Camera Cables

Adept sells a standard four-camera cable. A custom four-camera version is avail-
able for use with the Pulnix TM-1001. They all connect to the camera connector on
the front of the board. There is support for two strobe connections. The breakout
cable routes the signals away from the chassis—it does not connect directly to the
camera. To connect to the cameras, you must use an extension cable. Adept offers
a 10-meter cable for this purpose. These cables can also be purchased from Inter-
con 1. Contact Adept Applications Support for current Intercon 1 part numbers.
You can contact Intercon 1 at:
Intercon 1 Vision Products
Box 1C
Merrifield, MN 56465
(800) 237-9576 Voice
(218) 765-3900 FAX
See Tables to
7-7

Four-Camera Breakout Cable for RS-170 Cameras

This cable has a 44-pin D-sub connector on one end, and it breaks out to four
12-pin Hirose-style camera connectors and one 9-pin D-sub connector on the
other end. The length of the cable is 1.8 meters (70 inches).
Due to the current limitation of the VME bus specification, the EVI board cannot
supply enough current to operate all four cameras from the four-camera cable.
You must supply the external power to operate the cameras when using this
cable. This power must be routed through the 9-pin D-sub connector, see
7-4 and Table 7-9
Connect the power and ground on the breakout cable to a 12V power supply
producing 2.0A at 12VDC.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
for pin and signal information.
7-14
for pin information.
Adept MV Controller User's Guide, Rev. B

Camera Cables

Figure
147