10-Meter Camera Extension Cables; Custom Pulnix Tm-1001 Four-Camera Breakout Cable - adept technology MV User Manual

Chapter 7
To Camera/Strobe
To Camera/Strobe
connector on EVI
connector on
board
EVI module
Figure 7-4. Four-Camera Breakout Cable For RS-170 Cameras

10-Meter Camera Extension Cables

The 10-meter camera extension cables have a male Hirose connector on one end
and a female Hirose connector on the other end. These cables go between the
breakout cables and the connectors on the cameras. Each camera requires one of
these cables (or an equivalent).
This cable can be used with both RS-170 cameras and the Pulnix TM-1001 camera.

Custom Pulnix TM-1001 Four-Camera Breakout Cable

This cable available from Intercon 1 has a 44-pin D-sub connector on one end, and
it breaks out to four 12-pin Hirose style connectors and one 9-pin D-sub connector
on the other end. The length of the cable is 1.8 meters (70 inches). This cable is
used with the custom Pulnix TM-1001 D-sub to BNC adapter breakout cable,
described in the next section.
148
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
D-sub Auxiliary Connector Pin Assignments
D-sub Auxiliary Connector
Pin Assignments
Pin Signal
Pin Signal
1 User +12V to cameras
1 User +12V to cameras
2 User power return
2 User power return
3 Strobe 1
3 Strobe 1
4 Strobe return
4 Strobe return
5 Strobe 2
5 Strobe 2 6 Reserved
7 Reserved
6 Reserved
8 Reserved
7 Reserved
9 Shield (chassis ground)
8 Reserved
9 Shield (chassis ground)
Adept MV Controller User's Guide, Rev. B
Camera Cables
CAM 1
CAM 2
CAM 3
CAM 4
D-sub
D-sub
Auxiliary
Auxiliary
Connector
Connector