Controller Id Label; Facility Requirements - adept technology MV User Manual

Chapter 3

Controller ID Label

On the MV-5 and MV-10 controllers, the identification (ID) label is located on the
left or back side of the controller chassis. On it you will find the model and serial
numbers and the voltage and current ratings. A smaller serial number label is also
located on the front of the chassis near the On/Off switch (see
should always have this serial number available when you call Adept Customer
Service for technical support.
See "Adept MV-4 Insert Overview" on page 57
the Compact Controller.

Facility Requirements

The Adept controller is intended for use with other equipment and is considered
a subassembly rather than a complete piece of equipment on its own. The Adept
controller meets the requirements of EN 60204-1, EN 61131-2,
IEC 204, IEC 1131-2, IEC 73, and IEC 447 safety standards. To maintain
compliance with these standards, the controller must be installed and used
properly with any additional equipment in strict accordance with these
standards. For more information about safety and standards compliance, see
"Safety" on page
The Adept controller installation must meet the environmental and electrical
requirements shown in
Environment Variable
Ambient temperature
controller – while accessing floppy
or hard drive
controller – while not accessing
floppy or hard drive
Humidity
Altitude
Pollution degree
50
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
30, "Standards Compliance" on page
and
Table 3-1 Table
Table 3-1. Operating Environment Specifications
Adept MV Controller User's Guide, Rev. B

Controller ID Label

Figure
for the location of the ID label on
33, and Appendix
3-2.
Specification
5°C to 40°C (41 to 104°F)
5°C to 50°C (41 to 122°F)
5 to 90%, noncondensing
up to 2000 m (6500 ft.)
2 (per IEC 1131-2/EN 61131-2)
3-1). You
C.