Configuring An Awc Module; Factory Default Settings - adept technology MV User Manual

Chapter 4

Configuring an AWC Module

The AWC processors are shipped with the factory configuration described in
94%
( . If you need to make changes to this configuration, remove the AWC
processor and set DIP switch SW1 and jumper JP2 as described below.

Factory Default Settings

The factory default settings for DIP switch SW1 are as follows:
SW 4 SW 3 SW 2
OFF OFF OFF
With this default DIP switch setting, the system will read the configuration data
from the NVRAM chip. This allows you to set all the configuration options in
software without changing the physical DIP switches. See the description of the
CONFIG_C program in the
      .
78
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 4-2. DIP Switch SW1 Default Settings
SW 1 Interpretation
OFF CPU #1, normal operation (per
Adept MV Controller User's Guide, Rev. B

Configuring an AWC Module

/9-.
settings)