Table of Contents
Advertisement
Chapter 5
Connecting Customer-Supplied Safety and Power Control Equipment to the CIP
The CIP includes support for turning on and off system power to the controller. If
you use this switch, you must provide an AC contactor with the following
electrical characteristics:
•
12V or 24V, AC or DC coil, limited to less than 500 mA
The user connection for system power is at the JUSER connector (pins 6 and 24).
You will need to provide a power supply to match the coil voltage of the external
contactor.
In addition, the system power switch has a second pole that is wired through the
25-pin cable to the Manual Mode Safety Package. Access to this pole is at TB5,
pins 5 and 6, on the E-Stop PCA of the MMSP. You can wire to whichever contact
is more convenient.
Manual Mode Safety Package (MMSP) Connector
The CIP also provides a connection for a user supplied MMSP circuit (see
(
, '
(, 94%
(
, and
Remote User Panel Connections
The CIP provides connections for a remote user panel circuitry that allows a
second user panel at another location (see '
(
, '
(, 94%
(
, and
94%
(
for the customer remote user panel circuitry).
Remote MCP Connections
For the following remote MCP connections see '
(
, and '
(, and
94%
(
refer to
If a remote MCP connection has been added through the
JUSER connector, the optional MCP bypass plug (P/N 10335-01060)
must be installed in the MCP connector on the CIP.
Remote E-Stop Circuit
When using a remote connector for the MCP, the MCP E-stop push button
contacts (red mushroom switch) must be wired in series with any other E-stop
contacts on the "USERESTOP CH1"(pins 4 and 23) and "USERESTOP CH1" (pins
5 and 24).
108
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
94%
(
94%
(
and
for the customer Remote MCP circuitry.
Adept MV Controller User's Guide, Rev. B
for the customer MMSP circuitry).
'
- Quick Links:
- Developer's Manuals
Hide quick links:
Advertisement
Table of Contents
