Table of Contents
Advertisement
Chapter 4 - AdeptVision sAVI Option
4.4
Installing Camera Cables
Figure 4-3 on page 73
cable and the associated hardware in a SmartController CX system. See the
User's Guide
for information on mounting cameras and strobes in your system.
Connecting the Cables to the RS-170 Standard Camera
This section describes the steps for connecting the cables between the sAVI board and the
RS-170 Cameras.
1. Turn off the SmartController CX.
2. Connect the camera to a 10m camera cable.
3. Connect the 10m camera cable to the appropriate connection on the camera
breakout cable.
4. Connect the power supply and strobe lamps through the 9 pin D-sub connector
(see
Figure 4-2 on page 71
5. Connect the camera breakout cable to the Camera connector on the
SmartController CX.
72
shows the installation of a typical four-camera RS-170 breakout
CAUTION:
Turn off the controller before installing or
removing a camera or cable. Failure to do this may
damage the sAVI board.
CAUTION:
When using the four-camera breakout cable,
you must provide 12 VDC power at sufficient current for
the type and quantity of cameras you are using. See the
documentation supplied with your cameras for
information on current requirements.
and
Table 4-2 on page 76
Adept SmartController User's Guide, Rev. E
AdeptVision
for pin assignments).
Hide quick links:
Advertisement
Table of Contents
