ADTRAN Atlas 550 System Manual page 168

Section 4 User Interface Guide
M (N T1HSSI) > HSSI M
ODULES X
Read security: 5
Displays the current loopback status of the HSSI interface (see Figure 13). The following loopback status
messages may The following loopback status messages may display:
L DTE L
OCAL OOPBACK
L L L
OCAL INE OOPBACK
R L L
EMOTE INE
Remote Line Loopback
T1 Interfaces
M (N T1HSSI) > HSSI M
ODULES X
Read security: 5
(Not applicable when using the NxT1 HSSI/V.35 Option Module - P/N 1200346L2.) Displays the status of
the data Communications equipment Available (CA) signal from the DCE. CA will be asserted by the
DCE, independently of TA, when the DCE is prepared to both send and receive data to and from the DTE.
This indicates that the DCE has obtained a valid data communications channel. Data transmission should
not commence until TA has also been asserted by the DTE.
168
> S
ENUS
A local DTE Loopback occurs at the DTE port of the DCE, and is used
to test the link between the DTE and the DCE (NxT1 HSSI or NxT1
HSSI/V.35 Option Modules).
A local line loopback occurs in the IMUX engine and is sued to test
functionality between the DTE and the IMUX engine.
A remote line loopback occurs at the T1 interface and is used to test
OOPBACK
functionality between the DTE and the T1 interfaces.
Local Line Loopback
NxT1 HSSI
Figure 13. HSSI Interface Loopback Test Diagram
> S
ENUS
© 2004 ADTRAN, Inc.
> L
TATUS OOPBACK
IMUX
> CA
TATUS
ATLAS 550 System Manual
Local DTE Loopback
DTE
61200305L2-1B