ADTRAN Atlas 550 System Manual page 131

ATLAS 550 System Manual
M (V35N -2) > PLL/FIFO > P
ODULES X
Read security: 5
Indicates the operating port. There are 2 available interfaces on the Dual Nx56/64 Option Module.
M (V35N -2) > PLL/FIFO > PLL/FIFO
ODULES X
Read security: 5
Displays the state of the PLL and FIFO systems.
L PLL is locked (This is required to transfer data.)
OCK
RXE Receive data FIFO empty.
RXF Receive data FIFO full.
TXE Transmit data FIFO empty.
TXF Transmit data FIFO full.
M (V35N -2) > C
ODULES X
Write security: 3; Read security: 5
All of the following configurable parameters apply to the individual V.35 ports.
M (V35N -2) > C
ODULES X
Read security: 5
Displays the port number. There are 2 available interfaces on the Dual Nx56/64 Option Module.
M (V35N -2) > C
ODULES X
Write security: 3; Read security: 5
Accepts any alpha-numeric name up to 17 characters long, to uniquely identify each port on the Dual
Nx56/64 Option Module.
M (V35N -2) > C
ODULES X
Write security: 3; Read security: 5
Controls the clock used by the ATLAS 550 to accept the transmit (TX) data from the DTE. This is usually
set to . If the interface cable is long, causing a phase shift in the data, the clock can be set to
N
ORMAL
. This switches the phase of the clock, which compensates for a long cable.
I
NVERTED
M (V35N -2) > C
ODULES X
Write security: 3; Read security: 5
Controls the inverting of the DTE data. This inversion can be useful when operating with a high-level data
link control (HDLC) protocol (often used as a means to ensure 1s density). Select either
. Data inversion configuration must match at both ends of the circuit.
I
NVERTED
61200305L2-1B
ORT
ONFIGURATION
> P
ONFIGURATION RT
> P
ONFIGURATION ORT
> C
ONFIGURATION LK
> D
ONFIGURATION ATA
© 2004 ADTRAN, Inc.
Section 4 User Interface Guide
N
AME
+/-
or
N
ORMAL
131