ADTRAN Atlas 550 System Manual page 255
Adtran atlas 550: user guide
Hide thumbs
Also See for Atlas 550:
- User manual (262 pages) ,
- Q&a (22 pages) ,
- Configuration manual (11 pages)
Table of Contents
Advertisement
ATLAS 550 System Manual
D
P
> U
T
IAL
LAN
SER
Write security: 3; Read security: 5
Defines the type of signaling being used for this connection (endpoint). Select
bit signaling or
for a Primary Rate ISDN interface. This selection is only necessary if a T1/PRI is
PRI
selected as the
S
/P
LOT
ORT
One HDLC resource is used by each PRI or each Packet Endpoint.
D
P
> U
T
IAL
LAN
SER
Write security: 3; Read security: 5
Defines the parameters for the incoming calls that ATLAS 550 accepts from the network.
D
P
> U
T
IAL
LAN
SER
Write security: 3; Read security: 5
Identifies the call source ID from which this endpoint accepts calls. This field simplifies the creation of a
dial plan in applications where the criterion for switching calls to a certain endpoint is a function of which
endpoint originated the call.
X
[1,3,5]
0
The default ID for all source endpoints all accept numbers is 0. This results in all calls being routed based
on the dialed number.
D
P
> U
T
IAL
LAN
SER
Write security: 3; Read security: 5
Designates which numbers this endpoint will accept (terminate) from the network. The accept list may
consist of multiple entries. The numbers are defined using the following wildcards:
X
N
$
9
[1,2,3...]
Example: 963-8000 would be a specific incoming number that would be accepted by this endpoint. If this
endpoint consisted of a T1 with multiple DS0s, a "hunt" group for 963-8000 would be formed. The entry $
would accept any call.
Any specific entry will take precedence over a wildcard. For example, if endpoint A was
designated as $ while endpoint B accepted 963-800X, then an incoming call to 963-800X
would only be accepted by endpoint B.
61200305L2-1B
> S
ERM
IG
type.
> I
#A
ERM
N
CCEPT
> I
#A
> S
ERM
N
CCEPT
may be entered with the usual wild card entries (except $).
S
ID
RC
=
Any digit 0 through 9
=
Any of these digits
=
Default value
> I
#A
> A
ERM
N
CCEPT
=
Any single digit
=
Any single digit 2 through 9
=
Any number of digits of any value
=
This specific number
=
A single digit in this group
© 2004 ADTRAN, Inc.
ID
RC
N
CCEPT
UMBER
Section 4 User Interface Guide
for a T1 using robbed
RBS
255
Advertisement
Chapters
Table of Contents
