ADTRAN Atlas 550 System Manual page 133

ATLAS 550 System Manual
M (V35N -2) > C
ODULES X
Write security: 3; Read security: 5
Sends the state of the DTE leads to the remote unit whenever any of the leads change state. If any leads on
the remote unit are set to track a remote signal, this option must be enabled. The DTE lead states are
conveyed using the Inband control channel, which must be enabled.
SIGNAL RTS
CTS Follows
DCD —
DSR —
— = Do not care
Force On = On under all conditions
M (V35N -2) > D
ODULES X
Write security: 3; Read security: 5
Dials an Nx port that is configured to ignore DTR.
M (V35N -2) > D
ODULES X
Read security: 5
Displays the port number. There are 2 available interfaces on the Dual Nx56/64 Option Module.
M (V35N -2) > D
ODULES X
Write security: 3; Read security: 5
Configures the dialing mode. The following options are available:
P
ERSISTENT
O T
NE IME
M (V35N -2) > D
ODULES X
Write security: 0; Read security: 0
Signals the Nx port to dial/clear the call.
M (V35N -2) > D
ODULES X
Write security: 3; Read security: 5
Indicates the
S ID
OURCE
section of the
C
ONFIGURATION
M (V35N -2) > D
ODULES X
Write security: 3; Read security: 5
Indicates the number to be dialed. Configure this field in the Nx
.
D P
IAL LAN
61200305L2-1B
ONFIGURATION
V.54 511 TEST
LOOPBACK ON
Off Off
— —
Off Off
IAL
> P
IAL RT
> M
IAL ODE
Redial whenever the call is cleared or if the call fails.
Attempt the call only once.
> D
IAL IAL
> S ID
IAL RC
of the number to be dialed. Configure this field in the Nx
.
D P
IAL LAN
> N
IAL UMBER
© 2004 ADTRAN, Inc.
> S L
END EADS
SELF NETWORK
TEST TEST
ACTIVE ACTIVE
Off Off
Off Off
Off Off
I
NTERFACE
Section 4 User Interface Guide
NO DS0 NETWORK
MAPPED ALARM
Off Off
Off Off
Off
I
NTERFACE
section of the
C
ONFIGURATION
—
133