Advertisement
Advertisement
Table of Contents
Related Manuals for ADTRAN SMART/RG SR555ac
Summary of Contents for ADTRAN SMART/RG SR555ac
- Page 1 SR555ac Quick Start Guide...
-
Page 2: Installation
Installation Locate the splitter cable that is included with your SmartRG gateway. It has three ports. 1. Connect the splitter as follows: a. Connect the DSL port of the gateway and the Modem port of the splitter with a telephone cable b. - Page 3 RESET 3G USB Data Card / LTE RJ11 RJ45 Phone...
-
Page 4: Led Indicators
LED Indicators The indicator lights (LEDs) on the front of the SR555ac gateway can help you understand the state of your gateway. Legend: Green Green Blinking Lt. Blue Lt. Blue Blinking Dk Blue Dk. Blue Blinking Action Explanation All LEDs except Feature enabled &/or working correctly those listed below Data being transferred... - Page 5 Action Explanation DSL down By default, this LED will blink when the DSL connection goes down. You can modify this setting on the Advanced Settings > DSL page. Not lit No lines connected Note: This LED may flash green briefly on startup. INTERNET DSL sync acquired and gateway on line Data being transferred...
-
Page 6: Quick Gateway Configuration
Quick Gateway Configuration Warning: Do not press the Reset button unless you want to clear the current settings. The Reset button is in a small cir- cular hole on the rear panel. If you want to restore the default settings, insert a thin wire (such as a paper clip) into the hole, press gently for 1 second, and then release the button. -
Page 7: Configuring The Wan Manually
Configuring the WAN manually If the automatic connect process is unsuccessful, refer to the Advanced Setup > Layer 2 Interface WAN Services sec- tions of the SmartRG SR555ac Gateway User Manual to manually establish a connection. - Page 8 WiFi Setup Two methods, WPS and Manual, are available for WiFi setup. Perform the steps on this page first, and then follow the instructions for the applicable method. 1. In the left navigation bar, click Wireless. The Basic page appears. 2.
- Page 9 WPS Method If the device you wish to connect to the Internet via your gateway supports the WPS secure WiFi connection method, follow these steps. 1. In the left navigation bar, click Wireless. Then click Security for the wireless band that you want to configure. 2.
- Page 10 3. Within 2 minutes, activate on the 3rd party device to which you wish to connect. The device may have a push- button on its exterior or a software interface is used to initiate WPS connection. To learn how to use the WPS feature on your client device, refer to its documentation.
-
Page 11: Manual Method
Manual Method Set up your gateway’s parameters first, then follow these steps. 1. In the left navigation bar, click Wireless and then click Security for the wireless band that you want to configure. 2. Scroll down to the Manual Setup AP section. - Page 12 4. Select the desired Network Authentication. Make sure that the host devices you intend to use support the selec- ted authentication type. 5. Choose a WPA Passphrase and type it in to this field. You will need this passphrase for step 9. 6.
-
Page 13: Optional Wall Mount
Optional Wall Mount Using a Phillips-head screwdriver, remove the mount from its Gateway Front present location on the bottom of the gateway. Slide the mount onto the back of the gateway. Tighten the screw located in the bottom of the mount. Using the template below, mount the two included screws to 1/16”... -
Page 14: Additional Support
Predefined wireless settings If you change the preset wireless settings WiFi network name (SSID) Network key (password) Additional Support If you require further instructions, please contact your local ISP support. SmartRG Inc. an ADTRAN company. All Rights Reserved. © 2020...