ADTRAN Atlas 550 System Manual page 91

ATLAS 550 System Manual
S C > B
YSTEM ONFIG
Write security: 3; Read security: 5
Specifies the length of time the answering endpoint attempts to detect the BONDING negotiation pattern
from the originating endpoint before deciding the BONDING call has failed. It may be necessary to
shorten this timer if the DTE equipment using the BONDING module also has timer constraints for
completing non-BONDING parameter negotiation.
S C > B
YSTEM ONFIG
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to negotiate an agreeable value for bearer channels (B
channels) and channel capacities before deciding the BONDING call has failed.
S C > B
YSTEM ONFIG
Write security: 3; Read security: 5
Specifies the amount of delay between placing calls for outgoing BONDING sessions. The following call
stagger values are available:
S C > A
YSTEM ONFIG
Write security: 3; Read security: 5
Clears the Alarm Relay located on the back panel of the ATLAS 550. Activating the software Alarm Relay
Reset functions the same as manually pressing the
S C > A
YSTEM ONFIG
Write security: 3; Read security: 5
Defines which threshold sets the Alarm Relay. These thresholds include
, and . If an alarm occurs that is greater than or equal to the threshold selected, the Alarm
W N
ARNING ORMAL
Relay will set. For example, if the threshold is set for
alarms will set the Alarm Relay. There is one exception – setting the threshold to
Alarm Relay for
N
ORMAL
61200305L2-1B
C > TANULL T
ONDING ONFIG
C > TCID T
ONDING ONFIG
C > C
ONDING ONFIG
,
N S 500
O TAGGER
R R
LARM ELAY ESET
R T
LARM ELAY HRESHOLD
events. No events set the Alarm Relay.
N
ORMAL
© 2004 ADTRAN, Inc.
IMER
IMER
S
ALL TAGGER
, , and
1 2
MS SEC SEC
switch located on the ATLAS 550 front panel.
ACO
, then ALL
M
AJOR
Section 4 User Interface Guide
, ,
C M M
RITICAL AJOR INOR
alarms and ALL
M
AJOR
will not set the
N
ORMAL
,
C
RITICAL
91