ATLAS 550 System Manual
1.
EQUIPMENT DIMENSIONS
The ATLAS 550 base unit dimensions are 17.08" W x 11.67" D x 3.47" H. The option modules fit inside
the base unit.
2.
POWER REQUIREMENTS
The ATLAS 550 has a maximum power consumption of 60 W and a maximum current draw of 2 A
(AC System) or 5 A (DC System) regardless of the configuration of option modules installed in the base
unit.
3.
REVIEWING THE FRONT PANEL DESIGN
The front panel contains the Alarm Cut-off switch (
system controller, the network modules, and the option modules. Figure 1 identifies the
port, and the LEDs.
CRAFT
Craft
System Status
Port
LEDs
ACO Switch
Pressing the
switch deactivates (clears) the Alarm Relay, located on the back panel of the
ACO
ATLAS 550, after an alarm condition has occurred. If an alarm condition is corrected and then reoccurs,
the Alarm Relay re-energizes.
CRAFT Port (DB-9, female)
Use the
port to configure the system via an EIA-232 connection. Table 1 on page 28 gives the
CRAFT
port pinout.
CRAFT
61200305L2-1B
ACO
Network
ACO
Module LEDs
Switch
Figure 1. ATLAS 550 Front Panel Layout
© 2004 ADTRAN, Inc.
Section 2 Engineering Guidelines
), the
port, and the status LEDs for the
CRAFT
Option Module LEDs
switch, the
ACO
27