ADTRAN Atlas 550 System Manual page 350

Section 5 DLP-15
Perform the following steps below in the order listed:
1. Connect to the ATLAS 550 using either the ETHERNET, ADMIN, or CRAFT interfaces.
If you are not already connected to the unit's
compatible terminal or with a PC running VT100 emulation software, use the procedure in DLP-2,
Logging in to the ATLAS 550, to connect to the
Alternatively, if the unit is part of a management cluster connected to the local network, you may use a
PC connected to the network to Telnet into the unit. To connect to the
procedures in DLP-3, Setting IP Parameters for the ATLAS 550, and in DLP-4, Verifying
Communications Over an IP LAN.
2. Log in to the unit using the read-write password (see DLP-2, Logging in to the ATLAS 550, for details).
Configuring the Alarm Relay
1. Go to the S C
YSTEM
the A R T
LARM ELAY
will set for this threshold and all other alarms of greater importance. Refer to Section 7, System Event
Logging of this user manual for a listing of all alarms and levels of importance.
Setting the threshold to
N
ORMAL
(Optional) Configuring the Alarm Monitor for External Alarms
1. Go to the S C
YSTEM
select the E L
VENT OGGING
right-arrow key to access the right-pane menus.
2. From the E L
VENT OGGING
A R T
LARM ELAY HRESHOLD
set the A R
LARM ELAY
Clearing the Alarm Relay Remotely
1. Go to the S C
YSTEM
select the A R
LARM
Clear the
350
menu and press the right-arrow key to access the right-pane menus. Select
ONFIG
menu and choose the appropriate threshold level. The A
HRESHOLD
N
ORMAL
events set the
A R
LARM
menu and press the right-arrow key to access the right-pane menus. Then,
ONFIG
menu and press <Enter>. Once in the E
menu, select the E
. Any event on the A
.
menu and press the right-arrow key to access the right-pane menus. Then,
ONFIG
R field and press <Enter>.
ELAY ESET
locally by pressing the
A R
LARM ELAY
© 2004 ADTRAN, Inc.
or interface, either with a VT100
ADMIN CRAFT
or
ADMIN CRAFT
will not set the
A
LARM
.
ELAY
I menu and set it to the same value as the
XTERNAL NPUT
M will now be logged in the E
LARM ONITOR
switch on the front panel.
ACO
ATLAS 550 System Manual
interface.
interface, use the
ETHERNET
LARM
for events. No
R N
ELAY ORMAL
L menu, press the
VENT OGGING
VENT
61200305L2-1B
R
ELAY
L and
OG