ADTRAN Atlas 550 System Manual page 328

Section 5 DLP-7
Perform the following steps in the order listed.
1. Connect to the ATLAS 550 using the back panel's RJ-48 ADMIN interface or the front panel's DB-9
CRAFT interface.
If you are not already connected to the unit's
compatible terminal or with a PC running VT100 emulation software), follow the procedure in DLP-1,
Connecting a VT100 Terminal or PC to the ADMIN or CRAFT Port. Connecting to the
interface limits the upgrade procedure to XMODEM only.
CRAFT
2. Log in to the unit using the read-write password (see DLP-2, Logging in to the ATLAS 550 for details).
3. Go to the S U
YSTEM
4. Select the M
ODULE
Select the appropriate module slot to update. Select
Selecting
update.
5. Go to the T
RANSFER
6. From the R
ESTART
completing the update process.
R I
ESTART MMEDIATELY
R A S
ESTART T PECIFIED
you select this option, a new field called R
To use that option, enter the time in 24-hour format (such as 23:00:00 for 11:00 pm). Enter the date in
mm-dd-yyyy format (for example, 09-30-2000).
7. View C U
URRENT PDATE
errors encountered during the download.
8. Select B F
EGIN IRMWARE
module to receive the XMODEM upload.
When the ATLAS 550 is ready to receive the XMODEM upload, the menu screen will clear and
display Awaiting XMODEM Upload....<Ctrl-X> twice to Cancel. If this does not appear, please
review the steps above for possible configuration errors.
9. From the terminal emulation software, begin the XMODEM upload by using the appropriate command
sequence. This may take several minutes.
If necessary, refer to the terminal emulation software documentation for help. Also, when specifying
the filename, ensure that the file transferred is the one provided by ADTRAN. Otherwise, the update
will not complete successfully.
Because XMODEM data is being transferred inband through the menu interface, the VT100 menus of
the ATLAS 550 will be inoperable from the
any time within the terminal emulation software. (Please consult the documentation provided by the
terminal emulation software to determine how to do this).
328
menu and select the U
TILITY
S menu and press <Enter>.
LOT
A M T
LL ODULES OF A YPE
M menu and select XMODEM.
ETHOD
S menu, select the time for the module to perform a restart after
CHEDULE
A U
restarts the system immediately after the update is complete.
FTER PDATE
D T
ATE AND IME
S to verify the progress of the current firmware update or to identify any
TATUS
U to start the update. Enter Y to confirm the transfer and set up the
PDATE
© 2004 ADTRAN, Inc.
or interface (either with a VT100
ADMIN CRAFT
F
PDATE IRMWARE
to update the system controller.
S 0
LOT
and will force a controller reboot during the
S C
YS TRL
allows you to select when the updated system will restart. If
D T
ESTART ATE AND IME
or interfaces. You can cancel the update at
ADMIN CRAFT
ATLAS 550 System Manual
ADMIN
menu; press <Enter>.
displays below the current field.
61200305L2-1B
or