Dlp-4 Verifying Communications Over An Ip Lan - ADTRAN Atlas 550 System Manual

DLP-4 Verifying Communications Over an IP LAN

Introduction
When the port is connected to a local area network (LAN), test steps must be performed on
ETHERNET
the ATLAS 550 to ensure that the unit is communicating properly over the network. This procedure
outlines those steps.
Prerequisite Procedures
Before beginning this procedure, the unit should be physically connected to the LAN and the provisioning
tasks detailed in DLP-3, Setting IP Parameters for the ATLAS 550, should be complete.
Tools and Materials Required
• Access to a PC or other computer connected to the LAN
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling it,
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.
61200305L2-1B © 2004 ADTRAN, Inc. 317