ADTRAN Atlas 550 System Manual page 299

ATLAS 550 System Manual
D P (P E
IAL LAN KT NDPT
Write security: 3; Read security: 5
DBU H
ANDSHAKE
This option is only available when the packet endpoint selected in the
S DBU H
UPPORT ANDSHAKE
handshake upon connection. If the endpoint is configured to route incoming calls based on the handshake
information, this option is automatically enabled. If another call routing method is in effect, however, this
option can be enabled to support the use of handshake information at the far end of the link.
D P (P E
IAL LAN KT NDPT
Write security: 3; Read security: 5
Controls contents of the ADTRAN frame relay handshake upon connection of a backup PVC. Normally
this field should be set to
D P (P E
IAL LAN KT NDPT
Write security: 3; Read security: 5
(Visible only if is selected in the
G
ROUP
field. The ATLAS 550 will use the number entered here to compare to the number presented by the
incoming call when configured to route based on Call Party Number.
D P (P E
IAL LAN KT NDPT
Write security: 3; Read security: 5
Set this to 1 for typical single-call connections. A value greater than
supporting aggregation (e.g., BONDING) of the specified number of DS0s.
D P (P E
IAL LAN KT NDPT
Write security: 3; Read security: 5
Set this to 1 for typical single-call connections. A value greater than
endpoints supporting aggregation (e.g., BONDING) of up to the specified number of DS0s. This also sets
the number of DS0s presented in the negotiation of outgoing aggregate calls.
D P (P E
IAL LAN KT NDPT
Write security: 3; Read security: 5
This table is only visible if
selected routing option. For each case,
, as described above.
M /M DS0
IN AX S
61200305L2-1B
) > U T > I
SER ERM FCE
must be disabled for DBU between two ATLAS products.
enables/disables the generation and acceptance of ADTRAN frame relay
) > U T > I
SER ERM FCE
. The mode is present for compatibility with older IQ units.
A F
UTO ORCED
) > U T > I
SER ERM FCE
P /PEP
ORT
) > U T > I
SER ERM FCE
) > U T > I
SER ERM FCE
) > U T > I
SER ERM FCE
is selected in the
G
ROUP
C P
ALL ARAMS
© 2004 ADTRAN, Inc.
C > S
ONFIG UPPORT
P
ORT
C > S
ONFIG UPPORT
C > C P
ONFIG ALL
field.) Enter the expected calling part number in this
C > M DS0'
ONFIG IN
will restrict connections to endpoints
1
C > M DS0'
ONFIG AX
will accommodate connections to
1
C > C R
ONFIG ALL
field. The table format changes, based on the
P /PEP
RT
contain
O #, C
UTDIAL ALLER
Section 4 User Interface Guide
DBU H
ANDSHAKE
field has backup sublinks.
/PEP
DBU H
ANDSHAKE
N
ARTY UMBER
S
S
T
OUTING ABLE
and
ID, S ID,
OURCE
299