ADTRAN Atlas 550 System Manual page 270

Section 4 User Interface Guide
D P (T1/PRI) > U
IAL LAN
Write security: 3; Read security: 5
Determines how the ATLAS 550 switchboard uses B channels for call routing. The Circular method can be
used for call load balancing among the available B channels on this interface.
N
ORMAL
C
IRCULAR
D P (T1/PRI) > U
IAL LAN
Write security: 3; Read security: 5
Defines the response propagated to the CPE upon receipt of a
network.
N
ORMAL
P -T
ASS HRU
D P (T1/PRI) > U
IAL LAN
Write security: 3; Read security: 5
This menu allows the user to define option parameters for ports which emulate an RBS T1 connection from
the network.
D P (T1/PRI) > U
IAL LAN
Write security: 3; Read security: 5
Specifies the configuration parameters for the endpoint.
D P (T1/PRI) > U
IAL LAN
Write security: 3; Read security: 5
Defines the first DS0 for this endpoint.The ATLAS 550 uses DS0s, starting with this selection, to send and
receive calls to and from the network. The outgoing calls which are allowed or restricted over these DS0s
are set by
O #A
UT CCEPT
D P (T1/PRI) > U
IAL LAN
Write security: 3; Read security: 5
Specifies the number of DS0s ATLAS 550 uses for this endpoint.
270
T (P ) > I
SER ERM RI
Always start with the last channel configured (i.e., for a full PRI channel 23 would
be used if available).
Contiguous channels from last to first.
T (P ) > I
SER ERM RI
Send a Progress message to the CPE and map busy tones.
Send a
D U
ISCONNECT
T (RBS)
SER ERM
T (RBS) > I
SER ERM
T (RBS) > I
SER ERM
(see page 181) and
O
UT
T (RBS) > I
SER ERM
© 2004 ADTRAN, Inc.
C (P ) > B C
FCE ONFIG RI
C (P ) > B
FCE ONFIG RI
D
ISCONNECT
message to the User Term CPE device.
-B
SER USY
C (RBS)
FCE ONFIG
C (RBS) > F
FCE ONFIG
(see page 183).
#R
EJECT
C (RBS) > N
FCE ONFIG
ATLAS 550 System Manual
S
HANNEL ELECTION
O
USY PTION
message from the
U -B
SER USY
DS0
IRST
DS0
UMBER OF S
61200305L2-1B