ADTRAN Atlas 550 System Manual page 83

ATLAS 550 System Manual
S C > C
YSTEM ONFIG
Write security: 2; Read security: 5
Specifies whether you use
terminal, and mode is used for modem access.
D
IAL
S C > C
YSTEM ONFIG
Write security: 2; Read security: 5
Specifies the baud rate of the port. Select either
, ensure that the
P T
ORT YPE
S C > C
YSTEM ONFIG
Write security: 2; Read security: 5
Specifies the initialization string for the modem. Refer to your modem documentation for acceptable
initialization strings. The default value will configure most modems to the appropriate configuration for
the ATLAS 550.
S C > C
YSTEM ONFIG
Write security: 4; Read security: 5
Sends the modem initialization string to the modem. When you select this command, the following
message displays:
P
LEASE VERIFY A MODEM IS CONNECTED TO THE
( / ). Ensure that a modem is connected before selecting
C
ONFIRM Y N
S C > A
YSTEM ONFIG
Write security: 2; Read security: 5
This option sets the flow control for the
port flow control for
N
ONE
S C > SNMP
YSTEM ONFIG
Write security: 3; Read security: 5
Provides a way to configure SNMP access for the ATLAS 550. The following options are available for
review and editing:
S C > SNMP > SNMP A
YSTEM ONFIG
Write security: 3; Read security: 5
Defines whether SNMP access to the ATLAS 550 is
for your application.
S C > SNMP > SNMP C
YSTEM ONFIG
Write security: 3; Read security: 5
Defines SNMP manager(s) characteristics as follows:
61200305L2-1B
P > P T
HAIN ORT ORT
or mode.
D D
IRECT IAL
P > P S
HAIN ORT ORT
setting matches the modem baud rate.
P S
ORT PEED
P > M
HAIN ORT ODEM
P > I
HAIN ORT NITIALIZE
P > F
DMIN ORT LOW
ADMIN
or .
H
ARDWARE
CCESS
OMMUNITIES
© 2004 ADTRAN, Inc.
YPE
mode is used when connecting to a VT100
D
IRECT
PEED
, , , or
2400 9600 19200
I S
NITIALIZATION TRING
M
ODEM
C
HAIN PORT BEFORE CONTINUING
.
Y
C
ONTROL
or port. You may configure the
CRAFT
or
E D
NABLED ISABLED
Section 4 User Interface Guide
. If you are using
38400
ADMIN
. Select the appropriate option
for
D
IAL
.
or
CRAFT
83